Rabu, 09 Mei 2012

[MS_AccessPros] Re: Cannot make ACCDE

 

Like I told Duane--I'm embarrassed! Oh well, hopefully this will drill decompiling into my head.

Creates a question. Problem was that a combo I deleted months ago was referred to in the code. I might have cut and pasted code from and old db from 5/01/12 which does not refer to that combo in it's code. I checked a saved db from 4/01/12 and its code did not refer to that combo either.

Yesterday Access encountered an error and shut down. I decompiled, and compacted and repaired it. Can't believe that line of code would have been added. But can't figure out how it got there.

I'm guessing that you have no idea either. That I must have done something I don't recall. But just in case you have an idea, I'm asking.

Thanks for being here!
Connie

--- In MS_Access_Professionals@yahoogroups.com, "Bill Mosca" <wrmosca@...> wrote:
>
> Connie
>
> That message almost always means your code has some syntax errors in it and can't compile. Compiling is essential as an ACCDE is a pre-compiled file similar in many ways as a executable file.
>
>
> Open up the code window and click on Debug> Compile {your project name}.
>
> If it can't compile the editor will highlight the first line it finds that needs fixing. Keep compiling until you get an error-free compile.
>
> Regards,
> Bill Mosca, Founder - MS_Access_Professionals
> http://www.thatlldoit.com
> Microsoft Office Access MVP
> https://mvp.support.microsoft.com/profile/Bill.Mosca
>
>
>
>
> --- In MS_Access_Professionals@yahoogroups.com, mrsgoudge <no_reply@> wrote:
> >
> > Got that message today. So I went and cleaned up the forms, deleting quite a few ones that had been redone and were no longer being used. But that didn't make a difference. I created few (if any at all) forms/reports/macros/tables recently.
> >
> > Any input?
> >
> > Connie
> >
>

__._,_.___
Recent Activity:
.

__,_._,___

Tidak ada komentar:

Posting Komentar